Description

BOSS Air Bag Suspension Load Assist Kit WITH In-cab Control Kit - Great for towing & hauling heavy loads For: 2010-2017 Ford F250 & F350 - Including HD, Super Duty & Cab Chassis models **Does not fit with a 5th wheel hitch *drilling is required for this kit This kit will work with all height lift blocks. If you have a 3-6" lift using taller springs, you need the triple bag kit. The Load Assist Kit comes with: 2 x BOSS Extreme Series Double Bellow Airbags 4 x brackets (2 upper & 2 lower) Mounting Hardware Quality SAE J844 Government Approved Airline Dual Schrader Valves Mounted in Stainless Panel Instructions for fitting The In-cab control kit allows is used to control Boss Load Assist Kits or airbag suspension from inside your cab without the need for a tank and electric valves. Simple installation with control of airbags independently up and down using our PX02 compressor In-Cab Control Kit includes: 1 x PX-02 12V BOSS Air Compressor 1 x Stamped stainless steel gauge panel 2 x Pneumatic Push Buttons for dropping each bag 1 x 12V momentary switch for compressor 1 x BOSS 200psi Dual Needle back-lit Gauge 10 meters of 1/4” J844 DOT Airbrake line 1 x 1/4” push connect Y check valve 4 x Y Connectors 2 x T Connectors 4 x 1/4” female push fittings for gauge and buttons 10 x Cable Ties Instruction Sheet Boss Extreme series airbags are rated at 2500lb or 1136kg per side and have been tested to over 750psi. Average dual cab ute will run around 15-45psi depending on load. Boss has sold over 13000 load assist kits in Australia, proven over time with 4WD enthusiasts, Mining companies, Tradies, 4WD Tour Operators as well as in Agricultural Vehicles, Trailers and motor homes, limited only to your imagination. To get the best performance from your kit inflate airbags just enough to achieve a level ride height. By doing this you are also allowing all of the suspension components to share the extra load of the vehicle and not putting any unnecessary pressure on any one individual part of your vehicles suspension.