Description
This Kit Has Everything!! Plug and Play, All Wiring, Fuses, Hose, Fittings, Filters Gauges To Monitor All Four Air Bag Pressure Great Kit For Your C10 Or Custom Build Using an C10 Chassis Valve Manifolds Use Less Fittings, Easier and Cleaner Install Smooth Inflate/Deflate Read Below For Install Tips Check Out In Stock Air Ride Kits or Message Us With Questions!! Click Here Fits 2 Wheel Drive Models: 1973-87 C10 Truck Upgrades Available Message Us!!! Free Shipping USA 48 States Includes: airmaxxx Front Bolt On Air Bag Cups Ekstensive Metal Works Rear Weld On 2-Link (4) - airmaxxx 2600 air ride suspension bags airmaxxx 3/8" Valve Manifold airmaxxx 9ft Controller to Valve Harness airmaxxx 7 Switch Controller airmaxxx Chrome 480 Dual Air Compressors 150 on - 180 off Pressure Switch airmaxxx 5 Gallon 7 Port Steel Air Tank 50ft 3/8 DOT Air Hose 20ft 1/4 DOT Air Hose (gauges) Nickle Plated Brass Camozzi PTC Fitting Kit airmaxxx 3/8" Water Traps (2) 3/8" Element Filter Air Hose Cutter & Thread Sealer (2) Dual Needle White Face Air Gauges Gauge Mounting Panel The Rear 2-Link Kit is a comprehensive suspension solution for vehicles undergoing an air suspension conversion. This kit simplifies the installation process, offering pre-fabricated components that are ready for assembly and welding. Installation Breakdown: 1. Notch Installation- - The notch is a one-piece unit that slides over the truck's frame. - After positioning it correctly, it is welded to the frame. - The notch also includes pre-welded upper shock mounts on the crossbars for easier integration. 2. Frame Cutting and Reinforcement- - After the notch is welded in place, cut the frame in the required areas, especially the lower section, to allow for proper suspension travel. - Use the provided filler pieces to reinforce and box in the cut sections of the frame. 3. 2-Link Bars- - Install the 2-link bars onto the factory hangers . - The bars come pre-equipped with lower bag and shock mounts, simplifying bag and shock installation. - Secure the 2-link bars to the rear axle using the provided U-bolt kit . 4. Bag Mounts- - The upper bag mounts are positioned above the lower 2-link bag mounts. - Weld these upper mounts into place to complete the bag mounting setup. 5. Pan Hard Bar- - The panhard bar is a critical component for lateral support. - The notch has a built-in mount for the frame side of the bar, so bolt it onto this mount. - Weld the other end of the panhard bar mount to the rear axle for stabilization. Once all components are installed and welded, the suspension is ready to support an airbag system, providing a complete rear air ride setup. *Lifetime Warranty on Air Bags (WARRANTY DOES NOT COVER PUNCTURES, ABRASIONS, ABUSE OR POOR INSTALL) *1-year Warranty on Air Compressors